The Top Ten Deadlift Mistakes

Important!! The following is a text only archive!
For full features; Go to The Top Ten Deadlift Mistakes

posted by cupcake

The Top 10 Deadlift Mistakes by Dave Tate

Mistake #1: Training the deadlift heavy all the time

Very few people can train the deadlift week after week and still make progress. I feel the only ones who can get away with this are the ones who're built to deadlift. If you're built to pull, then the stress on your system is going to be less than those who aren't built to deadlift.

The deadlift is a very demanding movement and it takes a lot to recover from. This is compounded if you're also squatting every week. The squat and deadlift train many of the same muscles and this is another reason why you don't need to train the deadlift heavy all the time. Years ago the only deadlifts I did off the floor were in meets. The rest of the time was spent training the lower back, glutes, and hamstrings. While my deadlift increased 40 pounds over the first few years, I did run into some problems with this approach.

The major problem I had was when I'd go to a meet I didn't know where to place my feet and if I got stuck I didn't know how to adjust. Since I'm not built to deadlift, these things aren't natural to me. I had to find a way to put some pulling back in the program without taxing the system. What we came up with was a session of speed deadlifts with a moderate weight pulled for five or six singles. This way the weight was heavy enough to teach good form and not too heavy to tax the system. This worked out to 45 to 50% of max to be trained after the dynamic or speed squat workout. These don't need to be done every week but should be used as the meet or test day get closer.

I still suggest letting the box squat train the deadlift muscles with dynamic squat training of eight sets of two reps in a wave-like sequence. (For squat training details, see the following articles: Periodization Bible Part II, Squatting from Head to Toe, and TNT Part II for cycles and percentages.)

Let the max-effort day be for training the heavy deadlift. Try to pull off pins, off mats, or with bands one out of every four to six max effort days. Let the other day be some type of medium or close-stance good morning or low-box squat.

Mistake #2: Pulling the shoulder blades together

This is a mistake I made for years. Stand in a deadlift stance and pull your shoulder blades together. Take a look at where your fingertips are. Now if you let your shoulders relax and even round forward a little you'll see your fingertips are much lower. This is why we teach a rounding of the upper back. First, the bar has to travel a shorter distance. Second, there's less stress on the shoulder region. It'll also help to keep your shoulder blades behind the bar. You'll read more on this later.

Mistake #3: Rounding the lower back

This is another mistake I see all the time and most lifters know better. It happens most of the time because of a weak lower back or a bad start position. While keeping your shoulders rounded you must keep your lower back arched. This will keep the shin straight and the shoulders behind the bar and keep your body in the proper position to pull big while keeping the back under minimal stress.

If you pull with a rounded back, the bar is going to drift forward away from the legs, thus putting you back into a very difficult position from which to recover. When the bar drifts forward, the weight of it will begin to work against your leverages and cause you to have a sticking point just below the knees or mid-shin level. When you pull you can either arch your back in the beginning standing position before you crouch down to pull or once you grab the bar. Either way it's important to keep the lower back arched and tight.

There are many ways to strengthen the lower back for this. Good mornings, reverse hypers, and arched back good mornings are a few. You can also use a band around your traps and feet for simulated good mornings. With this technique you only use the bands and train for higher reps (in the 20 to 30 rep range) for local muscular endurance.

Mistake #4: Not having enough air in your belly

As with most exercise you must learn how to breathe. Stand in front of a mirror and take a deep breath. Do your shoulders rise? If so, then you need to learn how to breathe. Learn to pull your air into your diaphragm. In other words, use your belly! Pull as much air into your belly as possible, then when you think you have all you can get, pull more. The deadlift isn't started by driving your feet into the floor; it's started by driving your belly into your belt and hips flexors.

One note on holding air while you pull. You do need to try and hold your air as long as possible, but this can only last for a few seconds while under strain because you'll pass out. So for a long pull, you're going to have to breathe or you'll hit the floor and people will stare. While there are several people out there who may think this is a cool thing, I disagree. It's much cooler to make the lift!

So when you reach the point where you begin to really have to fight with the weight, let out small bursts of air. Don't let it all out at one time or you'll lose torso tightness and cause the bar to drop down. By letting out small bursts you can keep your tightness, continue to pull, and lock out the weight.

Mistake #5: Not pulling the bar back

The deadlift is all about leverage and positioning. Visualize a teeter totter. What happens when the weight on one end is coming down? The other end goes up. So if your body is falling backward, what happens to the bar? It goes up! If your weight is falling forward the bar will want to stay down. So if you weigh 250 pounds and you can get your bodyweight to work for you, it would be much like taking 250 pounds off the bar. For many natural deadlifters this is a very instinctive action. For others it has to be trained.

Proper positioning is important here. If you're standing too close to the bar it'll have to come over the knee before you can pull back, thus going forward before it goes backward. If your shoulders are in front of the bar at the start of the pull, then the bar will want to go forward, not backward. If your back isn't arched the bar will also want to drift forward.

For some lifters, not being able to pull back can be a muscular thing. If you're like myself, I tend to end up with the weight on the front of my feet instead of my heels. This is a function of my quads trying to overpower the glutes and hamstrings, or the glutes and hamstrings not being able to finish the weight and shifting to the quads to complete the lift. What will happen many times is you'll begin shaking or miss the weight. To fix this problem you need to add in more glute ham raises, pull-throughs and reverse hypers.

posted by president_fad

is it me, or did i not count 10?

posted by cosmic-dust

5 but they are still good pointers

* Add Your Comment - Ask a question *
Share the knowledge!

+
+
+
+
+
+ ...

+
+
------
+
+
+
------
+
+
+
+