Hcg

Important!! The following is a text only archive!
For full features; Go to Hcg

posted by wrstlng135

I am starting a cycle next week i got 9 amps of hcg (for the end of the cycle)but when i looked at them they are all solid, what can i do? :banghead:

posted by regino007

It should look solid only at the bottom of the amp.Shake it up and it should go back into suspension.

posted by wrstlng135

no liquid inside at all.

posted by jcvaughn26

what are you cycling? HCG????? HCG can cause perminent damage to your leydig cell if not use correctly. Personally I think it isn't a smart idea to run only HCG. No offense but it sounds like you haven't done your homework. Usually HCG comes with an amp of solvent and one of the powder. You can use bacteriostatic water, I believe.

posted by wrstlng135

jcvaughn, DID u even read what i wrote... its for the end of the cycle. Deca and dianabol is what i'm working with.

posted by jcvaughn26

"from the end of the cycle" doesn't really tell me what you were cycling that's why I asked. Anyway get some bacteriostatic water and mix with it 1ml per amp is common you'll have to do the math if you put more in shouldn't be tough. What do you plan on doing for dosing?

posted by wrstlng135

HCG
Week 12 5-7,500 i.u.
Week 13 5,000 i.u.
Week 14 5,000 i.u.

This is what I planned, were can i get bacteriostatic water from??

posted by jcvaughn26

spread out through the week?? I am hoping you aren't taking 7500ius in one dose. That's a little much all together, IMO. I think personally 500-1000ius ED for a week works for me. Then start your clomid or nolva whatever you are using after that. Most research chemical companies have bacteriostatic water.

posted by wrstlng135

I think your right it must be a mistake in the cycling info that i have, the amps are only 2,000 iu per.

* Add Your Comment - Ask a question *
Share the knowledge!

+
+
+
+
+
+ ...

+
+
------
+
+
+
------
+
+
+
+