test looks like ice

Important!! The following is a text only archive!
For full features; Go to test looks like ice

posted by CDubbs

I just took out by bottle of test cyp and it looks like the bottom of it froze. It looks like a mixture of ice and liquid. What is going on? I shook it and it looks the same. It is in my bedroom so its not like it is colder than 65degrees in there.

posted by jcvaughn26

Crashed. If it's an UG lab sometimes and hasn't been too long they'll usually send you another bottle if they are good. Otherwise, just put a needle in the stopper to relieve pressure went heating and heat it up until goes back into solution. You can add a little bb if needed.

posted by CDubbs

how do u heat it up?

posted by canibalistic_js

in a pot of water on the stove

posted by CDubbs

so im gonna put a needle in it and while the needle is in it still im gonna heat it till it melts in hot water? Or do i take the needle out before i heat? Thanks for the quick info

posted by CDubbs

and what is BB?

posted by Storm

Yea no prob at all just warm it up a bit you really don;t need to stick a needle to releave pressure some warm ater for a few min should do it..I have even done the micro for 20 sec shake it a bit then maybe another 10 sec if need be..Nothnig wrong with it at all..

posted by CDubbs

iight thanks alot

posted by canibalistic_js

It only takes a few minutes. Fill the pot half way up the side the bottle of test heat it up with the pin in the top and it will release any pressure build up.

posted by regino007

BA is what you should use to dissolve the crystals, not BB.

posted by Joe_Ice

lol..ice.... it crystalized.. re heat it and store it at room temp, no ibg deal

* Add Your Comment - Ask a question *
Share the knowledge!

+
+
+
+
+
+ ...

+
+
------
+
+
+
------
+
+
+
+